Lantronix SLC8 Manager User Manual page 159

Server #1 Secret
RADIUS Server #2
Server #2 Port
Server #2 Secret
Timeout
Custom Menu
Escape Sequence
Break Sequence
Enable for Dial-
back
Dial-back Number
Data Ports
Listen Port
Clear Port Buffers
Note: Older RADIUS servers may use 1645 as the default port. Check your RADIUS
server configuration.
SLC™ Console Manager User Guide
Text that serves as a shared secret between a RADIUS client and the server (SLC
device). The shared secret is used to encrypt a password sent between the client
and the server. May have up to 128 characters.
IP address or host name of the secondary RADIUS server. This server can be
used as a SecurID proxy.
Number of the TCP port on the RADIUS server used for the RADIUS service. If
you do not specify an optional port, the SLC console manager uses the default
RADIUS port (1812).
Text that serves as a shared secret between a RADIUS client and the server (SLC
device). The shared secret is used to encrypt a password sent between the client
and the server. May have up to 128 characters.
The number of seconds (1-30) after which the connection attempt times out. The
default is 30 seconds.
If custom menus have been created (see
page 148), you can assign a default custom menu to RADIUS users.
A single character or a two-character sequence that causes the SLC console
manager to leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is Esc+A (escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as \x1bA, which is
hexadecimal (\x) character 27 (1B) followed by an A.
This setting allows the user to terminate the connect direct command on the
command line interface when the endpoint of the command is deviceport, tcp,
or udp.
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is Esc+B (escape key,
then uppercase "B" performed quickly but not simultaneously). You would specify
this value as \x1bB, which is hexadecimal (\x) character 27 (1B) followed by a B.
Select to grant a user dial-back access. Users with dial-back access can dial into
the SLC device and enter their login and password. Once the SLC console
manager authenticates them, the modem hangs up and dials them back. Disabled
by default.
The phone number the modem dials back on depends on this setting for the
device port. The user is either dialed back on a fixed number, or on a number that
is associated with the user's login (specified here).
The ports users are able to monitor and interact with using the connect direct
command. U and L denote the PC Card upper and lower slots. U1 denotes the
USB port.
The ports users are able to monitor using the connect listen command.
The ports whose port buffer users may clear using the set log clear
command.
12: User Authentication
Local/Remote Users Commands on
159