Lantronix SLC8 Manager User Manual page 144

The top of the page has checkboxes for enabling local and remote users and for setting password
requirements. The bottom of the page displays a table listing and describing all local and remote
users.
To enable local and remote users capabilities:
1. Enter the following fields.
Enable Local Users
Multiple Sysadmin
Web Logins
Sysadmin Access
Limited to Console
Port
Authenticate only
users who are in the
remote users list
Complex Passwords
Allow Reuse
Reuse History
Lifetime (days)
Warning Period (days)
Max Login Attempts
Lockout Time
(minutes)
2. Click the Apply button.
SLC™ Console Manager User Guide
Select to enable all local users except sysadmin. The sysadmin is always
available regardless of how you set the check box. Enabled by default.
Select to allow the sysadmin to have multiple simultaneous logins to the web
interface. Disabled by default.
Select to limit sysadmin logins to the Console Port only. Disabled by default.
Select the check box to authenticate users listed in the Remote Users list in
the lower part of the page. Disabled by default.
Select to enable the SLC console manager to enforce rules concerning the
password structure (e.g., alphanumeric requirements, number of characters,
punctuation marks). Disabled by default.
Complexity rules:
 Passwords must be at least eight characters long.
 They must contain one upper case letter (A-Z), one lower case letter (a-z),
one digit (0-9), and one punctuation character (()`~!@#$%%^&*-
+=\{}[]:;"'<>,.?/_).
Select to enable users to continue to reuse old passwords. If you disable the
check box, they cannot use any of the Reuse History number of passwords.
Enabled by default.
Set the number of passwords the user must use before reusing an old
password. The default is 4. For example, if you set reuse history to 4, the user
may reuse an old password after using 4 other passwords.
Set the number of days until the password expires. The default setting is 90.
Set the number of days ahead that the system warns that the user password
will expire. The default setting is 7.
Set the number of times (up to 8) the user can attempt to log in unsuccessfully
before the system locks the user out. The default setting is 0 (disabled).
Set the number of minutes (up to 90) the locked-out user must wait before
trying to log in to the web interface again. The default setting is 0 (disabled).
12: User Authentication
144