Speaker Microphone; Optional Hm-184/Hm-184H; To Attach - Icom IC-F3260 Series Instruction Manual

7

SPEAKER MICROPHONE

Optional HM-184/HM-184H

■
PTT SWITCH
Hold down to
transmit;
release to receive.
Turn OFF the trans-
ceiver power when at-
taching or detaching
the microphone.
NEVER immerse the connector in water. If the connector
becomes wet, be sure to dry it BEFORE attaching it to the
transceiver.
NOTE: The microphone element is located at the top of
the speaker microphone, as shown in the diagram above.
To maximize the readability of your transmitted signal
(voice), hold the microphone Approximately 5 to 10 cm (2
to 4 inches) from your mouth, and speak at a normal voice
level.
29

To attach

■
Attach the connector of the speaker microphone into the multi
Microphone
connector on the transceiver and tighten the screw.
Speaker
Belt clip
IMPORTANT: KEEP the connector cover attached to the
transceiver when the speaker microphone is not in use.
(p. 3)
Water will not get into the transceiver, even if the cover is
not attached. However, the terminals (pins) will become
rusty, or the transceiver will function abnormally if the con-
nector becomes wet.
Screw
Coin
CAUTION: Firmly attach
to the multi connector, but
do not overtighten.
A loose connection will al-
low water intrusion into
the connector; an over-
tightened connection will
damage the connector
pins in the transceiver.