Table of Contents
Advertisement
3
BASIC OPERATION
Turning power ON
■
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 21)
q Rotate [VOL] to turn ON the power.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The 10-keypad can be used for password input, depending on
the transceiver version.
• The keys in the table below can be used for password input.
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
NUMBER
e If the "PASSWORD" indication does not clear after input-
ting 6 digits, the input code number may be incorrect. Turn
OFF the power and start over.
11
P0
P1
P2
P3
0
1
2
3
5
6
7
8
D
Battery type selection
When turning ON the transceiver, the battery type must be
selected according to the attached battery type.
Turn OFF the power.
q
While holding down [EMR] and [PTT], turn ON the power
w
with rotating [VOL] to toggle the attaching battery type.
• After the display appears, release [EMR] and [PTT].
• "DRY BATT" is displayed for about 3 seconds, then the low power
icon "Lo" appears when the battery case is selected. The trans-
mit output power is automatically set to low1.
• "LI-ION" is displayed for about 3 seconds when the Lithium-ion
battery pack is selected.
(Side1)
• This operation may not be available, depending on the presetting.
4
Ask your dealer for details.
9
Advertisement
Table of Contents
