Power Connector Cable - HP SpectreXT Maintenance And Service Manual

Power connector cable

Description
Power connector cable (includes bracket)
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Disconnect the power cable (1) from the system board.
2. Release the power cable from the clips (2) and the routing channel built into the top cover.
3. Remove the two Phillips PM2.0×4.5 screws (3) that secure the power connector and bracket to
the top cover.
4. Remove the power connector bracket (4).
Bottom cover on page 33).
Spare part number
700802-001
Battery on page 35).
Component replacement procedures
57