Wlan Module - HP SpectreXT Maintenance And Service Manual

WLAN module

Description
Intel Centrino Advanced-N 6235 Combo Adapter
CAUTION:
module authorized for use in the computer by the governmental agency that regulates wireless devices
in your country or region. If you replace the module and then receive a warning message, remove
the module to restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
labeled "1". The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal
labeled "2".
2. Remove the two Phillips PM2.0×3.0 screws (2) that secure the WLAN module to the system
board. (The WLAN module tilts up.)
To prevent an unresponsive system, replace the wireless module only with a wireless
Bottom cover on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal
33).
Battery on page 35).
Component replacement procedures
Spare part number
670292-005
37