Wlan Module - HP ENVY x360 Maintenance And Service Manual

Before removing the power connector cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the Phillips M2.0 × 3.7 screw (2) that secures the power connector cable and bracket to the
computer.
3. Remove the power connector cable bracket (3).
The power connector cable bracket is not available as a spare part.
4. Remove the power connector cable (4) from the computer.
To replace the power connector cable and bracket, reverse the removal procedures.

WLAN module

To remove the WLAN module, use this procedure and illustration.
Table 5-5 WLAN module descriptions and part numbers
Description
Intel AX211 Wi-Fi 6E + Bluetooth 5.3 M.2 2230 160 MHz CNVi worldwide (WW) WLAN module
Realtek 8852CE Wi-Fi 6E + Bluetooth 5.3 M.2 2230 PCI-e+USB WW WLAN module
IMPORTANT:
module authorized for use in the computer by the governmental agency that regulates wireless
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
Bottom cover on page
To prevent an unresponsive system, replace the wireless module only with a wireless
Preparation for disassembly on page
30).
Battery on page
30).
31).
Spare part number
M53366-005
M19618-005