Table of Contents
Advertisement
2.
Remove the heat sink (3) from the computer.
3.
Thoroughly clean the thermal paste from the surfaces of the heat sink and the system board
components each time the heat sink is removed. Replacement thermal material is included with the
heat sink and system board spare part kits.
Gray thermal grease (1) and white thermal grease (2) is used on specific system board components
and shown in the following illustration.
To install the heat sink, reverse this procedure.
NOTE:
When installing the heat sink, be sure to install the screws in the order shown on the heat sink.
WLAN module
To remove the WLAN module, use this procedure and illustration.
WLAN module
43
Advertisement
Table of Contents
