Setting Dtmf Signaling For Voip - Siemens Gigaset A580IP Manual

Setting the phone with the PC
Entering numbers
¤
Enter the network mailbox number in the Call number column after the desired
connection.
With some VoIP providers your mailbox number will be downloaded together
with the general VoIP provider data (
and displayed under Call number.
¤
Select Set to save your settings.
Activating/deactivating the network mailbox
¤
You can activate (
the option in the Active column. Activating/deactivating is carried out by select-
ing the appropriate option. The change does not need to be saved.
Please note
You need to have requested the network mailbox for your fixed line network con-
nection from your fixed line network provider.

Setting DTMF signaling for VoIP

DTMF signaling, for example, is required to check and control some network mail-
boxes via digit codes.
To send DTMF signals via VoIP you must first define how key codes should be con-
verted into and sent as DTMF signals: as audible information via the speech channel
or as a "SIP Info" message.
Ask your VoIP provider which type of DTMF transmission it supports.
¤
Open the following Web page: Settings
Area DTMF over VoIP connections
Make the required settings for sending DTMF signals.
¤
Activate Audio or RFC 2833, if DTMF signals are to be transmitted acoustically
(in voice packets).
¤
Activate SIP Info if DTMF signals are to be transmitted as code.
¤
Select Set to save your settings.
Please note
u
The settings for DTMF signaling apply to all VoIP connections (VoIP accounts).
u
DTMF signals cannot be transmitted in the audio path (Audio) on broadband
connections (the G.722 codec is used).
128
£
‰
) and deactivate (
Page 110), saved to your base station
) individual network mailboxes using
¢ ¢
Telephony Advanced Settings.