Setting Up The Handset For Use - Siemens Gigiaset SL37H Manual

Setting up the
handset for use
The display is protected by a
plastic film.
Please remove the
protective film!
Fitting the battery pack
Warning:
Only use the rechargeable Gigaset Communicati-
ons GmbH original battery pack (
use a conventional (non-rechargeable) battery or
other battery types as this could result in signifi-
cant health risks and personal injury. For
example, the batteries could explode. The phone
could also malfunction or be damaged as a result
of using batteries that are not of the recommen-
ded type.
¤
With the pins to the front, insert the bat-
tery pack into the cavity at an angle from
the left.
¤
Then press it into the housing from above
until the bracket on the side of the bat-
tery back snaps securely into the housing.
Please note:
To remove the battery pack, you must first
press the bracket on the side.
6
Closing the battery cover
¤
¢
S. 33)! Never
Attaching the belt clip
There are notches for attaching the belt clip
on the side of the handset at the same
height as the display.
¤
Opening the battery cover
¤
¤
¤
¤
Align the battery cover parallel to the
casing and press down until it clicks into
place.
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
If fitted, remove the belt clip.
Hold the device with the keypad facing
the palm of your hand.
Place the thumb of your other hand on
the loudspeaker (a) and use the index fin-
ger of the same hand to press the groove
at the top of the handset (b).
a
Lift the cover.
b