Table of Contents
Advertisement
Installation (for authorized personnel only)
Installation Warnings
• This appliance must be installed only by authorized persons and in accordance with
the manufacturer's installation instructions, local gas fitting regulations, municipal
building codes, electrical wiring regulations, AS 5601-2004: Gas Installations and
any other statutory regulations.
• Failure to follow all of the requirements may result in property damage, bodily injury,
or even death.
• This heater must be installed by an authorized person who has gone through a
training program for the installation of direct vent gas appliances.
• The heater is designed to operate on natural gas, or LPG. Ensure that the available
gas supply matches the Data Label.
• All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
• Notify your insurance company before hooking up this heater.
• The requirements listed below are divided into sections. All requirements must be
met simultaneously. The order of installation is not rigid – the authorized person
should follow the procedure best suited for the installation.
Packing List
•
Top Convection Deflector (with screws)
•
LPG Conversion Kit
•
Log Set
Additional Items Required
•
Faceplate
•
168 mm (6-5/8") to 76 mm (3") & 102 mm (4") Co-Linear Adapter - with flashing (Travis part # 98900124)
•
76 mm (3") and 102 mm (4") Diameter Gas Liner
•
Direct Vent Cap (Simpson Duravent Part # 991)
•
Gas Line Equipment (shutoff valve, pipe, etc.)
Items Packed with the Face
•
Face with attachment hardware and cove covers (if necessary)
•
Face Installation Instructions
Order of Installation
1
Install the Top Convection Deflector (see page 8).
2
If the heater is to use LPG, install the LPG conversion kit (see page 36).
3
Install gas line into the fireplace (do not connect to unit).
4
Position the heater.
5
Connect the gas line and gas vent to the appliance.
6
Install the optional surround panels and trim. Attach the on/off switch.
7
Follow the instructions under "Finalizing the Installation" on page 24.
© Travis Industries
•
Glass Latch Key (to un-latch glass frame)
•
"Fireplace Altered" tag (attach to the fireplace)
•
FPX Face Brackets (see pg. 11 for details)
4040808
7
100-01201_000
Advertisement
Table of Contents
