Optional Equipment; Lpg Conversion Instructions - Travis Industries DVL EF II Owner's Manual

36

Optional Equipment

LPG Conversion Instructions

Install the conversion kit prior to installing the gas line to ensure proper gas use.
1 Remove the glass (see page 20). Remove the logs and coals (if installed - page 22)
2 Remove the burner (see illustration below).
WARNING: Do not disassemble the burner – screws on the burner must be left in place.
c
Lift the left side of the
burner slightly, then slide it
to the left and lift it upwards
(lift the burner from below).
Burner Replacement:
Make sure the burner is fully seated.
When in place, the pilot flame must align
directly above the burner holes.
Make sure the mixing tubes
slide onto the orifices.
© Travis Industries
a
Remove the firebox floor.
WARNING:
The burner is fragile -
handle it with care.
d
Pull the burner forward, out
of the firebox.
Make sure the bolt head on
the bottom of the burner
inserts into this hole.
Mixing Tubes
(for authorized personnel only)
Lift the pilot hood off the pilot
b
assembly (you may need to
pull hard to remove).
Replace the pilot hood
after replacing the burner.
Orifices
4040808
Slide the air shutters all the
way to the right before
installing the burner.
NOTE:
Make sure the burner is
fully seated. When in
place, the pilot flame
must align directly above
the burner holes.
100-01201_000