Chapter 3 Initial Setup; Compactflash Card Installation; Chassis Grounding; Figure 3.1:Chassis Grounding Connection - Advantech UNO-2053E User Manual

Chapter 3 Initial Setup

3.1 CompactFlash Card Installation

The procedure for installing a CompactFlash card into the UNO-2053E is
as follows, please follows these steps carefully.
Step 1: Remove power cord.
Step 2: Unscrew four screws from the rear panel of the UNO-2053E.
Step 3: Remove the rear panel.
Step 4: Plug a CompactFlash card with user's OS and application
program into a CompactFlash card slot on board.
Step 5: Screw back the rear panel with four screws.

3.2 Chassis Grounding

Please connect the chassis ground of UNO-2053E with "EARTH".

3.3 Power Connection

Connect the UNO-2053E to a 10 ~ 30 VDC power source. The power
source can either be from a power adapter or an in-house power source.

3.4 BIOS Setup and System Assignments

UNO-2053E uses the Advantech SOM-2354 CPU module. For UNO-
2053E BIOS setup and system assignments, you can refer to SOM-2354's
Chapter 4 "Award BIOS Setup" and Appendix A "System Assignments".
The SOM-2354 user's manual is in the "Manual" folder on the CD-ROM.
Please note that you can try to "LOAD BIOS DEFAULTS" from the
BIOS Setup manual if UNO-2053E does not work properly.
UNO-2053E User Manual
Figure 3.1: Chassis Grounding Connection
12