Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
1.
Remove the power cord.
2.
Unscrew the four screws from the rear panel of the UNO-2170.
3.
Remove the rear panel.
4.
Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot on board.
5.
Screw back the rear panel with four screws.
Note:
The CompactFlash is allocated as "Secondary IDE Master".
3.2 Chassis Grounding
UNO-2170 provides good EMI protection and a stable grounding base.
There is an easy-to-connect chassis grounding point for you to use.
You can select if you wish to combine the chassis grounding point with
the system grounding by using an onboard jumper selection. (JP7)
UNO-2170 User Manual
Figure 3.1: Chassis Grounding Connection
Open - Separates system power ground and chassis
ground. (default)
Closed - Connects system power ground and chassis
ground.
16