Chapter 3 Initial Setup; Inserting A Compactflash Card; Chassis Grounding; Figure 3.1:Chassis Grounding Connection - Advantech Celeron M Universal Network Controller with PC/104 Extension UNO-2170 User Manual

Celeron m universal network controller with pc/104 extension

Hide thumbs Also See for Celeron M Universal Network Controller with PC/104 Extension UNO-2170:

Table of Contents

Chapter 3 Initial Setup

The procedure for installing a CompactFlash™ card into the UNO-2170

is detailed below, please follow these steps carefully.

1. Remove the power cord.

2. Unscrew the four screws from the rear panel of the UNO-2170.

3. Remove the rear panel.

4. Plug a CompactFlash™ card with your OS and application program

into a CompactFlash™ card slot on board.

5. Screw back the rear panel with four screws.

Note The CompactFlash™ slot is allocated as

The aluminum made UNO-2170 provides good EMI protection and a stable

grounding base. There is an easy-to-connect chassis grounding point for

you to use.

Please connect chassis ground of UNO-2170 with "EARTH" as ground.

Figure 3.1: Chassis Grounding Connection

UNO-2170 User Manual

Secondary IDE Master

＂

Table of Contents

Do you have a question about the Celeron M Universal Network Controller with PC/104 Extension UNO-2170 and is the answer not in the manual?