Removing The Airflow Guide - HP Integrity rx2660 User's & Service Manual

Removing the Airflow Guide

The airflow guide in the rx2660 server directs airflow from eight of the system fans to the processors
and the system memory on the system board. To install an additional processor or system memory,
you must remove the airflow guide (and optionally, the RAID battery).
To remove the airflow guide from the server:
1. Remove the top cover from the server. See
2. If the RAID battery is connected to the airflow guide, remove it before removing the airflow
guide. To remove the RAID battery:
a. Pull the RAID battery lock away from the RAID battery (1).
b. Slide the RAID battery toward the front of the server to disengage it from the airflow guide
(2).
c. Pull straight up on the RAID battery to remove it from the airflow guide.
Figure 17 Removing the Airflow Guide
3. Lift up on the fan carrier handle approximately 5 cm (2 in) to allow the airflow guide to be
lifted out of the server (1).
"Removing the Top Cover" (page
Installing Additional Components
46).
47