HP Integrity rx2660 User's & Service Manual page 178

1. Power off the server and disconnect the power cables. See
the Server" (page
2. If rack mounted, slide the server completely out from the rack. See
the Rack" (page
3. Remove the top cover. See
4. Loosen the three captive screws shown in
a. Press the blue button to release the black knob.
b. Turn the black knob counterclockwise until the captive screw is free from the system board.
5. Lift the power supply housing straight up and out of the server.
NOTE:
Figure 69 Removing the Power Supply Housing
178 Removing and Replacing Server Components
77).
141).
"Removing the Top Cover" (page
The power supply riser board comes out as part of the power supply housing.
"Powering On and Powering Off
142).
Figure 69 (page 178).
"Extending the Server from