Troubleshooting - MakerBot Replicator 2X User Manual

TROUBLESHOOTING

The Replicator 2X doesn't recognize
the SD Card
If your MakerBot Replicator 2X does not
detect that there is a card in the SD slot,
make sure the SD card is:
• an SDSC card formatted for FAT16
• no larger than 2GB.
Your MakerBot Replicator 2X can read only
cards that meet these requirements.
The default SD card that is shipped with
your MakerBot Replicator 2X is formatted
correctly and is of the correct size.
If the card is formatted correctly but your
MakerBot Replicator 2X fails to recognize
it, something may be wrong with the card.
Contact MakerBot Support.
The Replicator 2X doesn't see the files
on the SD Card
If your MakerBot Replicator 2X detects
the SD card but can't see the files on the
SD card, make sure that each file is in the
correct format.
Your MakerBot Replicator 2X can
read only files:
• that use the X3G format. To create an X3G
file in MakerWare, click Export to File in
the make dialog and select X3G from the
file type dropdown menu.
• with files name fewer than 26 characters;
30 characters if you count the file
extension. If you are trying to print an
X3G file with a long file name, shorten
it and try again.
The default SD card that is shipped with
your MakerBot Replicator 2X contains only
files of the correct format and with names
less than 26 characters.
If the files are formatted for X3G and the
file names have fewer than 26 characters
but your MakerBot Replicator 2X fails to
recognize them, something may be wrong
with the card. Contact MakerBot Support.
Printed objects don't stick to the build plate
If printed objects are not sticking to the
build plate, try these solutions:
• Re-level your build plate by going to
Utilities > Level Build Plate. Inconsistent
plate height will lead to inconsistent
adhesion. If any one part of your object
does not adhere well to the plate, the
whole object might peel off the plate.
Try leveling the plate again and using
a thinner piece of paper or feeler gauge
to check the distance.
• Ensure that the plate is clean. Bubbles,
scratches, dust, and oil from your hands
can prevent objects from sticking to the
Kapton tape. Wipe down the build plate
with a clean, lint-free cloth.
PRINTING FROM SD 41