MakerBot Replicator 2X User Manual page 15

ACCESSORY BOX
CONTINUED
3
Removing the Accessory Box
3a. Remove the two remaining protective
foam pieces from the bottom of the
MakerBot Replicator 2X's box.
3b. Lift out the accessory box. This box
contains the remaining items from the
Accessory Box section.
4
Freeing the Extruders
4a. Use strong scissors or a wire cutter to
cut the zip ties holding the gantry system
in place. Discard the zip ties and the plastic
pieces holding them in place.
4b. A small plastic piece attached to the
X-axis belt and gantry rods prevents the
extruder from moving. Carefully snap the
piece off of the rods and tilt it to slide it
off of the belt.
SETUP 15