Ice Transport Tube Replacement - Follett 110 Installation & Service Manual

Ice transport tube replacement

Top mount ice machines, model C/E110CT400A/W
!
Only use tubing supplied by Follett Corporation.
1
Ice transport tube replacement
Models C/E110FB400A/W, C/E110CR400A/W
! Correct installation of ice transport tube is critical to RIDE ice machine performance. Replacement ice
transport tubes for RIDE ice machines must be insulated and run continuously from ice machine to
dispenser with no dips or bends with a radius of less than 153mm (6").
1. Remove top and rear access panel from dispenser (lower front panel in
freestanding unit).
2. Disconnect existing ice tube from engaging pin on transport tube bracket in ice
storage bin evaporator and pull down through dispenser chase.
3. Disconnect opposite end of tube from ice machine.
4. Run end of new ice transport tube with 5mm (3/16") hole through ice transport
tube knock-out, (Fig. 5G) in back of dispenser or through counter into bottom of
dispenser, being careful to avoid any bends with less than 153mm (6") radius.
5. Insert tube in internal chase in rear inside corner of dispenser (left side as you
face dispenser) and push up into storage area.
6. Push the 5mm (3/16") hole near end of tube into pin on ice tube bracket
(see drawing below).
Steps 7-8 for units with RIDE ice machines only
7. Install supplied insulation to run of transport tube required for your site, leaving
approximately 51mm (2") of tube exposed at free end.
8. Check that insulated tube runs continuously uphill to dispenser with no dips.
20
3
2
110 Series 220 V 60 Hz/230 V 50 Hz Ice and Water Dispensers
TIGHTEN
CLAMP
SCREW
4
5mm (3/16")
dia. hole
Section A – A
26mm
(1")
A A