Installation And Operation; Installation Overview; Mounting The Interface; Tabletop Placement - Extron electronics DVI-RGB 150 User Manual

Installation and Operation

Installation Overview

To install and set up an Extron DVI-RGB 150 for operation,
follow these steps:
Turn off all of the equipment. Ensure that the video
1
sources and the output display are all turned off and
disconnected from the power source.
Mount the interface. See Mounting the Interface, below.
2
Connect the cables. See Rear Panel Connections and Controls
3
in this chapter.
Plug in the power supply, then turn on the display devices
4
and the input devices.
Set the level and peaking. See Front Panel Controls and
5
Indicator, on page 2-8.

Mounting the Interface

C
Installation and service must be performed by
authorized personnel only.
The 1" high, quarter-rack width interface can be placed on a
tabletop, mounted on a rack shelf, mounted under a desk or
tabletop, or mounted through a desk.

Tabletop placement

Affi x the four included rubber feet to the bottom of the unit and
place it in any convenient location.

Rack mounting

For optional rack mounting, mount the interface on any of the
following rack shelves:
• RSU 126 6" 1U deep universal rack shelf kit (part #60-190-
10) (fi gure 2-1)
• RSB 126 6" 1U deep basic rack shelf (part #60-604-10)
• RSU 129 9" 1U universal rack shelf kit (part #60-190-01)
(fi gure 2-2)
• RSB 129 9" 1U basic rack shelf (part #60-604-01)
The interface can be mounted in the front or the rear of the
full-size (non-6") rack shelves.
1. If installed, remove the feet from the bottom of the unit.
Mount the interface using two 4-40 x 3/16" screws in
2.
opposite (diagonal) corners to secure the unit to the shelf.
3. Install false faceplate(s) or other unit(s) to the rack shelf.
2-2 DVI-RGB 150 • Installation and Operation
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 2-1 — Mounting the unit on a 6-inch rack shelf
1U Universal Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Figure 2-2 — Mounting the unit on a standard rack shelf
DVI-RGB 150 • Installation and Operation
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
NOTE:
Using screws longer
than 3/16" will damage the
unit and void the warranty.
2-3