Flash; Moving Light Control; Control - ETC Element User Manual

Flash

Using the {Flash} softkey in Live will alternate the intensity level for selected channels or addresses
between full and 15% output every second. The channel or address will keep flashing until either
the command line is cleared, or [Next]/[Last] is used to increment to the next channel or address.
• [1]{Flash}[Enter] - will flash intensity for channel 1.
• [Next] - channel 1 returns to its previous state and the intensity for channel 2 will flash.
• [Dimmer/Address] [1][0]{Flash}[Enter] - will flash intensity for address 10.
You can also use [Shift] & [Full] and [Shift] & [Out] to briefly flash levels. While [Shift] & [Full] is
depressed, selected channels will be held at full. While [Shift] & [Out] is depressed, selected
channels will be held at zero.

Moving Light Control

For more information about the ML Control display, see
information on programming moving lights, please see the
www.etcconnect.com/product.tutorial.aspx?ID=22010.
6
Basic Manual Control
Moving Light Control, page
Element tutorials, http://
134. For more
85