Connecting Power; Installing A Hard Disk; Bios Setup And System Assignments - Advantech UNO-2170 User Manual

Celeron m universal network controller with pc/104 extension

Hide thumbs Also See for UNO-2170:

Table of Contents

3.3 Connecting Power

Connect the UNO-2170 to a 9~36 VDC power source. The power source

can either be from a power adapter or an in-house power source.

The procedure for installing a hard disk into the UNO-2170 is below.

Please follow these steps carefully.

Remove the power cord.

Unscrew four screws from the rear panel of the UNO-2170.

Remove the rear panel.

Connect the IDE flat cable to Primary (recommended; CN8) or sec-

ondary IDE connector (CN16), then connect the other side of the

connector to the hard disk.

Screw back the rear panel with the four screws.

UNO-2170 adopts Advantech's SOM-4486 CPU module. Further infor-

mation about the SOM-4486 CPU module, can be found in SOM-4486's

user's manual. You can find this manual on the UNO-2170's driver and

utility CD-ROM.

Please note that you can try to "LOAD BIOS DEFAULTS" from the

BIOS Setup manual if the UNO-2170 does not work properly.

Chapter 3

Table of Contents