Figure 1-3 Patch Panel Connection Between A Terminal Server And A Sparc Enterprise T2000 Server; Table 1-2 Pin Crossovers For Connecting To A Typical Terminal Server - Fujitsu SPARC Enterprise T2000 Administration Manual

Connect a serial interface breakout cable to a patch panel and use the straight-
■
through patch cable (supplied by your server's manufacturer) to connect the
patch panel to the server.
Patch Panel Connection Between a Terminal Server and a SPARC Enterprise
FIGURE 1-3
T2000 Server
If the pinouts for the serial management port do not correspond with the pinouts for
the RJ-45 ports on the terminal server, you need to make a crossover cable that takes
each pin on the SPARC Enterprise T2000 server serial management port to the
corresponding pin in the terminal server's serial port.
shows the crossovers that the cable must perform.
TABLE 1-2
Pin Crossovers for Connecting to a Typical Terminal Server
TABLE 1-2
SPARC Enterprise T2000 Serial Port (RJ-45
Connector) Pin
Pin 1 (RTS)
Pin 2 (DTR)
Pin 3 (TXD)
Pin 4 (Signal Ground)
Pin 5 (Signal Ground)
Pin 6 (RXD)
Pin 7 (DSR /DCD)
Pin 8 (CTS)
Terminal Server Serial Port Pin
Pin 1 (CTS)
Pin 2 (DSR)
Pin 3 (RXD)
Pin 4 (Signal Ground)
Pin 5 (Signal Ground)
Pin 6 (TXD)
Pin 7 (DTR)
Pin 8 (RTS)
Chapter 1 Configuring the System Console 11