To Reconfigure A Device Manually; Displaying System Fault Information - Fujitsu SPARC Enterprise T2000 Administration Manual

Device Identifiers and Devices (Continued)
TABLE 2-5
Device Identifiers (Continued)
IOBD/PCIEb
TTYA
MB/CMP0/CHchannel_number/Rrank_number/Ddimm_number

To Reconfigure a Device Manually

▼
1. At the sc> prompt, type:
sc> enablecomponent asr-key
where the asr-key is any device identifier from
Note – The device identifiers are not case sensitive. You can type them as uppercase
or lowercase characters.
You can use the ALOM CMT enablecomponent command to reconfigure any
device that you previously unconfigured with the disablecomponent command.

Displaying System Fault Information

ALOM CMT software lets you display current valid system faults. The showfaults
command displays the fault ID, the faulted FRU device, and the fault message to
standard output. The showfaults command also displays POST results. For
example:
sc> showfaults
Adding the –v option displays the time:
sc> showfaults -v
ID FRU Fault
0 FT0.FM2 SYS_FAN at FT0.FM2 has FAILED.
ID Time
0 MAY 20 10:47:32
Devices (Continued)
PCI-E leaf B (/pci@7c0)
DB9 Serial Port
DIMMS
TABLE 2-5
FRU Fault
FT0.FM2 SYS_FAN at FT0.FM2 has FAILED.
Chapter 2 Managing RAS Features and System Firmware 41