Automatic System Recovery User Commands; Enabling And Disabling Automatic System Recovery; To Enable Automatic System Recovery - Fujitsu SPARC Enterprise T2000 Administration Manual

Automatic System Recovery User Commands

The ALOM CMT commands are available for obtaining ASR status information and
for manually unconfiguring or reconfiguring system devices. For more information,
see:
"Unconfiguring and Reconfiguring Devices" on page 40
■
"To Reconfigure a Device Manually" on page 41
■
"Obtaining Automatic System Recovery Information" on page 39
■
Enabling and Disabling Automatic System
Recovery
The automatic system recovery (ASR) feature is not activated until you enable it.
Enabling ASR requires changing configuration variables in ALOM CMT as well as
OpenBoot.
▼

To Enable Automatic System Recovery

1. At the sc> prompt, type:
sc> setsc diag_mode normal
sc> setsc diag_level max
sc> setsc diag_trigger power-on-reset
2. At the ok prompt, type:
ok setenv auto-boot true
ok setenv auto-boot-on-error? true
Note – For more information about OpenBoot configuration variables, refer to the
service manual for your server.
3. To cause the parameter changes to take effect, type:
ok reset-all
38 SPARC Enterprise T2000 Server Administration Guide • April 2007