Controlling The Locator Led - Fujitsu SPARC Enterprise T2000 Administration Manual

LED Behaviors with Assigned Meanings (Continued)
TABLE 2-2
Color Behavior
Steady On
Yellow/Amber Off
Slow Blink
Steady On
Green Off
Standby Blink
Steady On
Slow Blink

Controlling the Locator LED

You control the Locator LED from the sc> prompt or by the locator button on the
front of the chassis.
Definition Description
Steady State If blue is on, a service action can be performed on the
applicable component with no adverse
consequences.
For example: the OK-to-Remove LED
Steady State
1Hz repeating This indicator signals new fault conditions. Service is
sequence, equal required.
intervals On
For example: the Service Required LED.
and Off.
Steady State The amber indicator stays on until the service action
is completed and the system returns to normal
function.
Steady State
Repeating The system is running at a minimum level and is
sequence ready to be quickly revived to full function.
consisting of a
For example: the System Activity LED
brief (0.1 sec.)
ON flash
followed by a
long OFF
period (2.9 sec.)
Steady State Status normal; system or component functioning
with no service actions required
A transitory (temporary) event is taking place for
which direct proportional feedback is not needed or
not feasible.
Chapter 2 Managing RAS Features and System Firmware 31