To Perform A Nonmirrored Disk Hot-Swap Operation - Fujitsu SPARC Enterprise T2000 Administration Manual

5. To check the status of a RAID rebuild, type the following command:
# raidctl
For example:
# raidctl
RAID Volume
Volume Type
--------------------------------------------------------
c0t1d0 IM
This example indicates that RAID volume c0t1d0 is resynchronizing.
If you issue the command again once synchronization has completed, it indicates
that the RAID mirror is finished resynchronizing and is back online:
# raidctl
RAID Volume
Volume Type
--------------------------------------------------------
c0t1d0 IM
For more information, see the raidctl(1M) man page.
▼ To Perform a Nonmirrored Disk Hot-Swap
Operation
1. Verify which hard drive corresponds with which logical device name and physical
device name.
See "Disk Slot Numbers, Logical Device Names, and Physical Device Names" on
page 49.
Ensure that no applications or processes are accessing the hard drive.
RAID RAID
Status Disk
RESYNCING c0t1d0
c0t2d0
RAID RAID
Status Disk
OK c0t1d0
c0t2d0
Disk
Status
OK
OK
Disk
Status
OK
OK
Chapter 3 Managing Disk Volumes 61