Example: Configuring Mobile Access Gateways For Dual-Stack Pmipv6 - Cisco Intelligent Wireless Access Gateway Configuration Manual

Example: Configuring Mobile Access Gateways for Dual-Stack PMIPv6

exit
port ethernet 17/1
exit
port ethernet 17/3
exit
port ethernet 17/4
exit
end
Example: Configuring Mobile Access Gateways for Dual-Stack PMIPv6
ipv6 mobile pmipv6-domain D1
replay-protection timestamp window 255
mn-profile-load-aaa
server
lma lma1
ipv6-address 2003::4
ipv4-address 16.1.1.2
mag M1
ipv6-address 2002::4
ipv4-address 15.1.1.1
nai MN1@example.com
apn example.com
lma lma1
service dual
int att ETHERNET l2-addr 0000.1111.2222
!
ipv6 mobile pmipv6-mag M1 domain D1
no discover-mn-detach
sessionmgr
apn example.com
address ipv6 2002::4
address ipv4 15.1.1.2
binding maximum 40000
replay-protection timestamp window 255
interface GigabitEthernet0/0/2
enable pmipv6 default MN1@example.com
lma lma1 D1
ipv6-address 2003::4
ipv4-address 16.1.1.2
encap gre-ipv4
Intelligent Wireless Access Gateway Configuration Guide
74
bind address aaaa:bbbb::2
exit
pgw-service pgw1
plmn id mcc 100 mnc 200
associate lma-service lma2
exit
ipv6 route 2002::/64 next-hop aaaa:bbbb::1 interface lma2
ip igmp profile default
exit
boxertap eth4
no shutdown
bind interface lma2 pgw
vlan 200
no shutdown
exit
no shutdown
#domain with name D1 configuration
#subscriber service profile downloaded from AAA
#associating LMA with name lma1 to domain D1
#associating MAG with name M1 to domain D1
#local subscriber NAI definition for authotrization,
where service for this particular NAI is defined
#dual stack is enabled for MN1@example.com client
Dual Stack Support for PMIPv6 and GTP
OL-30226-03