Cisco Intelligent Wireless Access Gateway Configuration Manual page 35

IP Sessions Over Gigabit EtherChannel
Command or Action
Step 2
interface port-channel channel-number
Example:
Router(config)#interface port-channel 1
Step 3 description string
Example:
Router(config-if)#description GEC:1 interface
towards switch
Step 4
ip address ip-address mask [secondary [vrf vrf-name] ]
Example:
Router(config-if)#ip address 21.0.0.1 255.255.0.0
Step 5 load-interval seconds
Example:
Router(config-if)#load-interval 30
Step 6 lacp fast-switchover
Example:
Router(config-if)#lacp fast-switchover
Step 7 lacp max-bundle max-bundle-number
Example:
Router(config-if)#lacp max-bundle 1
Step 8
service-policy type control policy-map-name
Example:
Router(config-if)#service-policy type control
BB_PMAP
Step 9 ip subscriber {l2-connected}
Example:
Router(config-if)#ip subscriber l2-connected
Step 10 initiator {dhcp | radius-proxy | static ip subscriber list
listname | unclassified ip | unclassified mac-address}
Example:
Router(config-subscriber)# initiator unclassified
mac-address
OL-30226-03
Configuring IP Sessions over Gigabit EtherChannel
Purpose
Creates a port-channel virtual interface.
Adds a description to an interface configuration.
Removes an IP address from an interface.
Changes the length of time for which data is used to
compute load statistics.
Enables the LACP 1:1 link redundancy.
Defines the maximum number of active, bundled LACP
ports allowed in a port channel.
Applies a control policy to a context.
Enables Cisco Intelligent Services Gateway (ISG) IP
subscriber support on an interface, and specifies the
access method that IP subscribers use for connecting
to the Cisco ISG on an interface.
Note The iWAG does not support the routed access
method.
Enables the Cisco ISG to create an IP subscriber session
upon receipt of a specified type of packet.
Intelligent Wireless Access Gateway Configuration Guide
27