Ancp Client Port Identifier - Cisco Catalyst 4500 Series Command Reference Manual

ancp client port identifier

ancp client port identifier
To create a mapping for an ANCP client to identify an interface on which ANCP should start or stop a
multicast stream, use the ancp client port identifier command.
Syntax Description identifier name
vlan number
interface
Defaults This command has no default settings.
Command Modes Global configuration mode
Command History Release
12.2(50)SG
Usage Guidelines The ANCP server can use either the DHCP option 82 circuit ID or an identifier created with this
commandto identify the port. Use only one of the two methods; do not interchange them. If you use the
DHCP option 82, the port identifier used by the ANCP server should be (in hex) 0x01060004[vlan][intf].
For example, VLAN 19 and interface Fast Ethernet 2/3 will provide 0x0106000400130203. If you use
the port identifier, however, use the exact string provided on the CLI.
This command is available only after you set the box in ANCP client mode with the ancp mode client
Note
configuration command.
Examples This example shows how to identify interface FastEthernet 7/3 on VLAN 10 with the string NArmstrong:
Switch# ancp client port identifier NArmstrong vlan 10 interface FastEthernet 7/3
Related Commands Command
ancp mode client
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-16
ancp client port identifier identifying name vlan vlan number interface interface
Identifier used by the ANCP server to specify an interface member of a VLAN.
VLAN identifier.
Interface member of this VLAN.
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Sets the router to become an ANCP client.
OL-27596 -01