Installation: All Models Other Than The Display Sensor; Mounting The Back Plate - Trane Wired Temperature Sensors Installation, Operation And Maintenance Manual

Installation: All Models Other Than the Display Sensor

This section provides step-by-step installation instructions for all sensor models other than the
display sensor. (For installation of the display sensor, see
information before proceeding with the installation.
Note: Before installing a wired sensor, ensure that a wire access hole is available at the sensor

Mounting the Back Plate

Hazardous voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power cannot be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
NOTICE
Equipment damage!
Applying excessive voltage to the sensor will permanently damage it.
1. Shut off power to the unit controller.
2. Remove the cover by firmly pressing the thumb tab at the bottom of the cover and pulling the
BAS-SVX10C-EN
location and the wire is accessible through the hole. The technician should assume that the
wires are attached to the appropriate unit controller, that there is continuity between the
location and the controller, and that the wires are accurately labeled or identified by color.
WARNING
cover away from the back plate.
Note: If present, remove the security screw before removing the cover.
p. 9.) Read through the pre-installation
17