TIPTEL 83 VoIP User Manual page 49

are switched same as a hub. This way you can e.g. connect a PC to the LAN port of
your tiptel 83 VoIP which is located in the same network.
LAN-IP .......................... Enter an IP address defined by you. You need to
Netmask....................... Enter the applicable subnet mask.
DHCP Service .............. Activate DHCP service in case your tiptel 83 VoIP
NAT .............................. Activate NAT in case your tiptel 83 VoIP does not
Bridge mode ................ Activate the bridge mode to have both ports of your
When you activate/deactivate the bridge mode your tiptel 83 VoIP will perform
a restart without notification.
Configuration
programme another address range as at the WAN
port.
In bridge mode this IP address has no effect.
should act as a DHCP server at the LAN port.
In bridge mode this IP setting has no effect.
work in bridge mode and you wish to use it a gate-
way. In case you deactivate NAT and bridge mode
at the same time then WAN and LAN port will create
two different networks.
In case you wish to use your tiptel 83 VoIP in your
PC as gateway then you will have to enter the LAN
IP of your tiptel 83 VoIP as gateway address in your
PC.
With NAT activated your tiptel 83 VoIP may no
longer be accessible via the WAN port. In this case
please use the LAN port.
tiptel 83 VoIP behave like a hub. In this case your
tiptel 83 VoIP can also be accessed through the
LAN port via the IP address set under WAN settings.
Deactivate the bridge mode in case you are operat-
ing different networks at WAN and LAN port. In this
case tiptel 83 VoIP can be accessed through the
LAN port via the IP address set under LAN settings.
49