Ribbon Load - Intermec EasyCoder PM4i User Manual

Chapter 5—Thermal Transfer Printing

Ribbon Load

The EasyCoder PM4i can print on labels, tickets, tags, and continuous
stock using either direct thermal printing on special heat-sensitive media
or thermal transfer printing using a special ink-coated ribbon.
Thermal transfer printing makes it possible to use a wide range of receiv-
ing face materials and gives a durable printout less vulnerable to fat,
chemicals, heat, sunlight etc. than direct thermal printing. Make sure to
select a type of ribbon that matches the type of receiving face material
and to set up the printer accordingly.
The EasyCoder PM4i can use transfer ribbon rolls wound with the ink-
coated side facing either outward or inward. Illustrations in this manual
show the ink-coated side facing inward.
Even if ribbon usually is loaded in connection with media replenishment,
no loaded media are shown in the illustrations in this chapter in order to
give a clearer view of the ribbon path. Refer to Chapter 4 for media load
instructions.
Most transfer ribbons do not smear at room temperature.
Note: Save the label indicating the sensitivity number attached
to the ribbon roll. You will need this number to set the media
sensitivity, see Appendix E.
34 Intermec EasyCoder PM4i—User's Guide (IPL version)