Intermec EasyCoder PM4i User Manual page 120

Appendix E—Intermec Supplies
The sensitivity number on each roll of thermal transfer media or ribbon
has an asterisk (*) in place of one of the digits. To optimize the sensitiv-
ity number for thermal transfer media, you combine the digits as in this
example.
Media or Ribbon
Thermal transfer media
Thermal transfer ribbon 5*7
To set the sensitivity rating for direct thermal media, use the three-digit
sensitivity rating located on the roll of media or listed later in this chap-
ter.
Use DOS to set the media sensitivity number on a PC like this:
1. At the DOS prompt, type the following command and press Enter:
MODE COM1 96,E,7,1,N
2. Type the following command lines and press Enter:
COPY CON COM1
<STX><SI>g1,567<ETX>^Z
where:
<SI>g1,567
112
Sensitivity
Rating
56*
567
sets the media sensitivity number to 567.
Intermec EasyCoder PM4i—User's Guide (IPL version)
Description
The asterisk for the third digit is reserved to
identify the ribbon's sensitivity number.
The asterisk for the second digit is reserved
to identify the media's sensitivity number.
Optimum sensitivity rating