Intermec EasyCoder PM4i User Manual page 113

Appendix D—Supported IPL Commands
IPL Command Syntax
Status Dump .................................................................................<VT>
Status Enquiry ............................................................................<ENQ>
Test and Service Mode, Enter ....................................................<ESC>T
Test and Service Mode, Exit .................................................................R
Top of Form, Set ...........................................................................<SI>F
Transmissive Sensor Value, Transmit .................................................... G
User-Defi ned Characters (UDC) and Graphics, Print .......................... g
User-Defi ned Character, Clear or Create ............................................. G
User-Defi ned Character Field, Create or Edit ...................................... U
User-Defi ned Characters, Transmit ............................................ <ESC>u
User-Defi ned Font Character, Create .................................................... t
User-Defi ned Fonts, Print ..................................................................... t
Warm Boot ....................................................................................<BS>
Width of Line, Box, Bar, or Character, Defi ne ......................................w
Intermec EasyCoder PM4i—User's Guide (IPL version) 105