The Setup Mode is organized as an endless loop, from which you can
select a number of sub-categories. At startup, the fi rmware determines
if options such as a label taken sensor, a cutter, or an interface board is
installed in the printer. Only installed options are shown in the Setup
Mode.
The diagram below shows the options in the main loop. Detailed over-
views are shown on the pages that follow.
SETUP:
SER-COM
SETUP:
CONFIGURATION
SETUP:
MEDIA
Intermec EasyCoder PM4i—User's Guide (IPL version)
Starting point
Chapter 7—Setup Mode
SETUP:
NETWORK
Option
SETUP:
TEST/SERVICE
53