Intermec PC23 User Manual page 59

PC23 and PC43 Desktop Printer User Manual
Note: If you are using an icon printer, you must use Intermec PrintSet
to configure the cutter. For LCD printers, continue with the next step.
8 After the printer finishes starting up, press
9 Select Settings > Printing > Cutter .
10 In the Cutter Control options, select Automatic.
11 Press or
12 Press to save your changes and exit the Settings menu.
13 Adjust the media feed as required. Intermec recommends the
following values for cut-off printing:
Recommended Feed Adjust Values for PC43d
Setting 203 dpi
Start Adjust -294
Stop Adjust 170
Recommended Feed Adjust Values for PC43t
Setting 203 dpi
Start Adjust -372
Stop Adjust 264
Note: You may need to adjust the recommended values slightly
depending on your media type, supply method, and roll sizes, or
because of individual differences between printers.
. A "Save Changes?" message appears.
300 dpi
-434
251
300 dpi
-550
389
Chapter 2 — Set Up the Printer
.
Distance
-36.80 mm (-1.45 in)
21.3 mm (0.84 in)
Distance
-46.60 mm (-1.45 in)
33 mm (0.84 in)
45