Use Scandiagnostic To Troubleshoot The Scanner; Troubleshoot Operating The Computer - Intermec CK70 User Manual

Chapter 8 — Troubleshoot and Maintain the Computer

Use ScanDiagnostic to Troubleshoot the Scanner

Troubleshoot Operating the Computer

Problems Operating the Computer
Problem
You press the Power button and
nothing happens.
120
Use the ScanDiagnostic application to troubleshoot problems such as
the inability to read a bar code or a scanner that does not turn on.
1 From the Home menu, tap Start > ScanDiagnostic.
2 From the Scan Health screen, select the scanner you want to
troubleshoot and then tap Diagnose.
The application checks to make sure the scanner is enabled and
checks settings to make sure they are optimized.
3 From the Scan Test screen, press and hold the Press to Scan
button while aiming at the bar code you want to read.
After the computer scans the bar code, it beeps and the label data,
data length, and symbology appear on the screen.
4 Press the right arrow button to view any recommended settings.
5 To accept the recommended settings, tap Apply.
6 Tap OK to exit.
Use this section to troubleshoot problems that may prevent you from
being able to operate the computer.
Solution
Try the following solutions:
•
Replace or charge the battery. The battery may be completely
drained.
•
Remove the battery and press the Reset button to perform a
cold boot. For help, see
page 123
"Cold Boot the Computer" on
.
70 Series Mobile Computer User Manual