Pod Scanner: H2Podscn.exe, Tethered Scanner: H2Thrscn.exe - Intermec 6110 Technical Reference

DOS Support
Pod Scanner: H2PODSCN.EXE,
Tethered Scanner: H2THRSCN.EXE
Overview
Pod Scanner
The program H2PODSCN is the pod scanner. It collects and passes scanned
data to an application via the standard DOS type-ahead buffer, where the
scanned bar code is available to an application as simple keystrokes. The
program also manages power for the scan operations.
H2PODSCN is an internal scanner. Its features are as follows:
"
"
"
"
Tethered Scanner
H2THRSCN is the tethered scanner. Its features are as follows:
"
"
"
"
Installation and Configuration
H2PODSCN is generally installed from the AUTOEXEC.BAT file using the
following statement:
H2PODSCN [–option[value]] ...
This program must be installed after the CardSoft drivers and TSRs are
installed (if they are used) and after NORDOSPM.EXE is installed. Also, if
CardSoft drivers and TSRs are present in the system, the command line option
on NORDOSPM.EXE that "fixes" some CardSoft bugs (/ss:1) must not be used
on NORDOSPM.EXE.
Make sure the following files are located in the C:\Drivers directory on your
6110 Computer:
NORDOSPM.EXE
H2PODSCN.EXE
H2THRSCN.EXE
NORDOSPM.EXE should already be in the flash, all other files listed above can
be found in the toolkit.
4-24 6110 Hand-Held Computer Technical Reference
I/O is transferred through the standard DOS type-ahead buffer
Scanner provides the capability of a fully decoded RS-232 scanner
Handles SE1223 hardware
Baud rate: 19200
I/O is transferred through the 9-pin D-sub serial port connector
Scanner provides the capability of a fully decoded RS-232 scanner
Handles SE1223 hardware.
Baud rate: 9600
(see the Usage paragraph below)
SECTION 4