Radio Configuration Bar Codes; 2D Configuration Bar Codes - Intermec CK70 User Manual

Appendix C — ScanNGo Wi-Fi Configuration Bar Codes

Radio Configuration Bar Codes

2D Configuration Bar Codes

178
Use the following ScanNGo bar codes to enable the 802.11 radio and
set the defaults for either Funk or Microsoft Wireless Zero
Configuration security. After you scan the bar codes, you will still need
to use Intermec Settings or another configuration program to set
network-specific settings on your computer and to configure the
wireless security.
The CN70, CN70e, and CK70 are available with the EA30 imager only.
The CK71 has three imager options: the EA30, EX25, or EV12 imager.
If your CK71 has an EA30 or EX25 imager, use the 2D configuration
bar codes to configure the radio. If your CK71 has an EV12 imager, use
the 1D configuration bar codes to configure the radio. You can find
out what imager is in your CK71 by opening Intermec Settings and
tapping Data Collection > Internal Scanner > Scanner Settings.
Note: If you are using Microsoft security, you can only use the 1D
configuration bar codes.
The following ScanNGo bar codes were created using SmartSystems
Foundation. For more information on SmartSystems Foundation, see
"Manage the Computer Using SmartSystems" on page
You can configure the computer with a 2D imager (EA30 or EX25).
1 Scan the appropriate bar code from the table and wait for the
program to start.
2 Follow any instructions on the device.
70 Series Mobile Computer User Manual
106.