Table of Contents
Advertisement
User Manual
Aastra DT69x DECT Telephones
SERVICE NEEDED
Hardware error
Note: This display
message is only shown
in English
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
SERVICE NEEDED
Invalid IPDI
Note: This message is
only shown in English.
Enter PIN code
Battery low, charge
now
Phonebook is not
available at the
moment.
Voice mail number not
defined
Could not encrypt
connection
LED Error Indications
See also chapter
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third telephone, that is another telephone than the "old" (the replaced telephone)
and "new" (the replacement telephone) telephone, is inserted into the charger during
Easy Replacement, this error indication appears. Change to the correct telephone.
2) The charger has found that Easy Replacement does not work. Change back to the
"new" telephone.
05 October 2012 / Ver. PH1
PRELIMINARY
There is a communication
problem between components in
the telephone.
Telephone is defective.
Easy replacement procedure not
followed correctly or failure
during easy replacement
procedure.
The telephone's lock is activated. Enter the required PIN code. If
The battery level is low.
The phonebook does not
respond, not available at the
moment.
There is no Voice mail number
defined in the telephone.
The parameter "Encryption
Required" is enabled in the
handset in combination with;
1) Unencrypted base station(s);
and/or,
2) Unsupported base station(s).
LED Indications during Easy Replacement
TD 92474EN
Send the telephone for service.
Select the reset option on the
middle soft key and upgrade
the telephone's software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the telephone for
service.
Send the telephone for service.
PIN code lost enter new via
PDM or do a factory reset via
PDM.
Charge the battery while it is in
the telephone, or remove the
battery and replace or charge it
separately.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Define a Voice mail number via
PDM.
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Enable the encryption in the
base station(s); and/or,
3) Use supported base
station(s). Ask your supplier.
on page 63.
55
Advertisement
Table of Contents
