Access Panel/Hood (Removing/Installing); Removable Seat (Zr/Xf) - Arctic Cat XF 7000 Operator's Manual

Hide thumbs Also See for XF 7000:
Table of Contents

Advertisement

CAUTION
If the snowmobile is equipped with
ice scratchers, the scratchers must
be disengaged or component dam-
age will occur.
Access Panel/Hood
(Removing/Installing)
To remove the access panel and hood, use
the following procedure:
6000
7000
1. Remove the hairpin clip from the pin
located at the front of the access
panel. Move the panel up and off the
pin; then swing the panel all the way
out and unhinge the panel from the
lower console.
2. On the M, remove the thumb screw
securing the front left access panel
to the front facia. Move the panel up
and off the pin; then swing the panel
all the way out and unhinge the
panel from the lower console.
3. Remove the torx-head screws secur-
ing the hood (located on the underside
of the hood above the front tube of the
upper A-arm); then remove the torx-
head screws from the top-side of the
hood securing the hood to the upper
console and the torx-head screws
from under the nosepiece of the hood.
4. Remove the intake panel below the
gauge; then locate the hood harness
connector (located in front of the
speedometer) and unplug the con-
nector; then move the hood slightly
forward and remove the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector making sure the harness
does not become pinched.
0746-793
NOTE: On the 6000, make sure the
hood tabs are seated between the
throttle body boot.
2. Secure the hood with torx-head
screws and tighten securely.
3. Install the access panel onto the lower
console; then close the access panel
and secure with the hairpin clip and
thumb screw. Install the intake panel.
0747-529

Removable Seat (ZR/XF)

These snowmobiles are equipped with a
removable seat. To remove the seat,
remove the screw from the underside of
the seat; then lift on the back of the seat
and move it up and rearward to remove it.
CAUTION
On the LXR prior to removing the seat,
lift the rear of the seat and disconnect
the seat heater harness connector.
0746-800
6000
746-088A
17

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

M 6000Zr 6000Zr 7000

Table of Contents