Configuring Tampering Alarm Settings - Lorex LNR300 Instruction Manual

Client Software for PC or Mac
• Select one of the standard templates or select Template01~08 and click Edit to create a
custom template. Click and drag on each day to configure when motion detection is
enabled. Click Save when finished making changes.
• Click Confirm to save changes to the schedule.
7 Under Warning, check to enable the following warnings when motion is detected:
• Full Screen Monitoring: The selected channel will open in full screen.
• Audible Warning: System will beep.
• Notify Surveillance Center: An alert will be sent to the client software.
• Send Email: An alert email will be sent. Note that you must set up email alerts. For details,
see "Configuring Email Alerts" on page 70.
8 Under Triggered Camera, select which channels will start to record when motion detection is
triggered on the selected channel.
9 Click Save to save changes.

Configuring Tampering Alarm Settings

The Tampering Alarm is activated if the camera lens is covered, for example if a vandal
sprays paint on the camera.
To configure Tampering Alarm settings:
1 Under Camera, select the camera you would like to configure.
2 Click Tampering Alarm.
3 Check Enable Tampering Alarm to enable the Tampering Alarm on the selected camera or
un-check to disable.
4 Click and drag in the video display area to enable areas the camera will watch for tampering.
Click and drag to select
Tampering Alarm areas
126