Overwrite; Enabling/Disabling Overwrite - Lorex LNR300 Instruction Manual

5 Click Detect to begin the scan. The NVR will scan the hard drive for bad sectors and show the
results in the chart. Green blocks are normal sectors, and red blocks are damaged sectors.
The hard drive scan may take up to a couple hours. If you exit the Bad Sector Detection
sub-menu, the scan will be paused.

Overwrite

Enabling/Disabling Overwrite

Overwrite is enabled by default. When overwrite is enabled, the NVR will begin to overwrite
the oldest video footage when the hard drive is full. If Overwrite is not enabled, the NVR will
stop recording when the hard drive is full.
To enable/disable overwrite:
1 Right-click and then click Menu
2 Enter the system user name (default: admin) and password (default: 000000) and click Yes.
3 Click HDD>Overwrite.
4 Check Overwrite to enable overwrite or un-check to disable.
5 Click Apply to save your settings.
Select hard drive
Start bad sector test
Check to enable
Overwrite
HDD
49