Power Trim And Tilt Switch On Bottom Cowling; Power Trim And Tilt Switches (Twin Binnacle Type) - Yamaha F200 Owner's Manual

1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on the
side of the bottom cowling. Pushing the switch
" " (up) trims the outboard motor up, and
then tilts it up. Pushing the switch "
tilts the outboard motor down and trims it
down. When the switch is released, the out-
board motor will stop in its current position.
For instructions on using the power trim and
tilt switch, see page 68.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
operator, increasing the risk of collision
with another boat or an obstacle.
UP
DN
1. Power trim and tilt switch
EMU26163
Power trim and tilt switches (twin bin-
nacle type)
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pushing the switch "
ZMU07849
board motor up, and then tilts it up. Pressing
the switch "
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position. For instructions on using the
power trim and tilt switches, see pages 66 and
68.
" (down)
UP
1. Power trim and tilt switch
Components
" (up) trims the out-
" (down) tilts the outboard motor
1
DN
1
ZMU07741
ZMU04601
32