Power Trim And Tilt Switch On Bottom Engine Cowling; Power Trim And Tilt Switches (Twin Binnacle Type) - Yamaha Z300A 2003 Owner's Manual

EMU26150
Power trim and tilt switch on bottom
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, then tilts it up. Pressing the switch
" " (down) tilts the outboard motor down
and trims it down. When the switch is re-
leased, the outboard motor will stop in its
current position.
EWM01030
WARNING
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
" (up) trims the outboard
Basic components
UP
DN
NOTE:
For instructions on using the power trim and
tilt switch, see page 36.
EMU26161
Power trim and tilt switches (twin
binnacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, then tilts it up. Pressing
the switch " " (down) tilts the outboard mo-
tor down and trims it down. When the switch
is released, the outboard motor will stop in its
current position.
NOTE:
On the dual engine control, the switch on
G
the remote control grip controls both out-
board motors at the same time.
For instructions on using the power trim
G
and tilt switches, see pages 34 and 36.
ZMU01862
" (up) trims the
12