Controls; Engine Shut-Off Cord (Lanyard); Engine Oil - Yamaha F200 Owner's Manual

EMU40541

Controls

Turn the steering wheel fully to port and
●
starboard. Check that operation is smooth
and unrestricted throughout the whole
range with no binding or excessive free
play.
Operate the remote control lever several
●
times to check that there is no hesitation in
its travel. Operation should be smooth over
the complete range of motion.
Inspect the throttle and shift cable connec-
●
tions for damage and looseness.
EMU40362

Engine shut-off cord (lanyard)

Check the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
1. Clip
2. Engine shut-off cord (lanyard)
ZMU07751
1
2
ZMU06873
EMU40993

Engine oil

1. Place the outboard motor in a vertical po-
sition (not tilted). NOTICE: If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01861]
2. Remove the oil dipstick and wipe it clean.
1. Oil dipstick
3. Insert the oil dipstick completely and re-
move it again.
4. Check that the oil level on the oil dipstick
is between the upper and lower marks.
Consult your Yamaha dealer if the oil lev-
el is not at the proper level or if it appears
milky or dirty.
1
1. Oil dipstick
2. Upper mark
3. Lower mark
Operation
1
ZMU07752
2
3
ZMU07753
56