Operation
be damaged. If the engine will not start
after 5 seconds of cranking, return the
main switch to "
onds, then crank the engine again.
[ECM00192]
EMU36510
Checks after starting engine
EMU41360
Cooling water
Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the cooling water pilot hole shows that
the water pump is pumping water through the
cooling water passages.
TIP:
When the engine is started, there may be a
slight delay before water flows from the cool-
ing water pilot hole.
ECM02250
NOTICE
If water is not flowing out of the cooling
water pilot hole at all times while the en-
gine is running, overheating and serious
damage could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
1
1. Cooling water pilot hole
63
" (on), wait 10 sec-
ZMU07766
EMU27670
Warming up engine
EMU41231
Procedure for warming up engine
1.
After starting the engine, warm up the en-
gine until the engine speed stabilizes at
idle speed to provide maximum operating
performance and acceleration. Failure to
do so will shorten engine life.
2.
Check that the low oil pressure-alert indi-
cator remains off. NOTICE: If the low oil
pressure-alert indicator blinks after
the engine starts, stop the engine.
Otherwise, serious engine damage
could occur. Consult your Yamaha
dealer.
[ECM02380]
EMU36531
Checks after engine warm up
EMU36541
Shifting
While the boat is tightly moored, and without
applying throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU40460
Stop switches
Perform the following procedure to check that
the main switch and engine shut-off switch
operate properly.
Check that the engine stops when the main
●
switch is turned to the "
Check that the engine stops when the clip is
●
pulled from the engine shut-off switch.
Check that the engine cannot be started
●
with the clip removed from the engine shut-
off switch.
EMU31733
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
" (off) position.