Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Cowling - Yamaha F40G Owner's Manual

Components
1. Nut
Nut tightening torque:
5.7 Nm (0.57 kgf-m, 4.2 ft-lb)
TIP:
Steering movement is blocked when the

adjuster lever is set to the "A" position.
Check the tiller handle for smooth move-

ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to

the friction areas of the steering friction ad-
juster.
EMU26143
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 62 and 65.
26
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch "
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
" (up) trims the
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 65.
EWM01031
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
falling overboard and could distract the
" (up) trims the outboard motor up,
WARNING
"